HightLight:
Fiber optic cleaver is suitable for cold seal and can solve hot melt of a versatile fiber optic cutter.
The SKL-6C Fiber Optic Cleaver uses 16-bit high-strength blade planes.
It has a longer service life, comes with triple accessory that can flex, cut fiber and bare fiber, automatic back knife slide.
Easy to use. You just need to put a good fiber blanket on the lid. Then, to push, you can complete all the cutting work.
Product description
Specification:
Applicable diameter of fiber bar: 125μm.
Applicable quality of fiber core: single core (0.25 and 0.9 mm),2.5 fiber 12 core ribbon covered yarn.
Fiber optic cutting length: 18 mm.
Use:
1. Lift the top lever of the fiber optic cover. Open the clamp of the single core fiber clamp. Confirm the slider of the blade in the forward position.
2. Place the optical fiber into the groove of the single-core fiber clamp. Align the coating line with the appropriate cutting length scale of the optical fiber. (For example, if the cutting length is 18 mm, align the overlap line to the 18 mm position on the ladder). Then check the bare fiber if it is straight.
3. Optical fibers and chips are very tiny and sharp. If it gets into the finger or eye, everything will cause injury. Therefore, you need to be very careful during the operation. For safe use, the operator must wear protective glasses.
4. Please dispose of the fibre chips in the container, separated from household waste.
5. The cutter installed in the machine is very sharp. Do not touch it with your hands, otherwise it may hurt your hands.
Warning:
1. When replacing the non-optical adjustment blade, you may not be able to replace and install the blade, nor adjust the cutting force.
2. SKL-6C adopts the special fixing screw of the cutter and there is no need to adjust the height of the cutter even by turning the cutting bar.